NI Climbing Frames Double Climbing Frame, Assembly Instructions Manual

Page: 3 / 13

pg. 3
Step1: Ground Preparation

Lay out the base, slide and the 10ft swing pole in the position that you intend the climbing
frames to be placed.

Allow for 6 ft clearance beyond the end of the slide and 4 ft clearance for the steps, rock
module and swing module.

Once you are happy that the layout is correct, remove the swing pole, steps and rock wall
and slide.

Mark out clearly all 4 ends of the base area

If the climbing frame is on a level surface then dig 4 holes of diameter 12” and depth 12”.
The tricky part is when the surface is uneven; in this case you would have to compensate for
the slope by making some holes deeper than others (minimum depth of 12”).
The bottom
of all 4 holes need to be level
Step2: Base Preparation

Lay 2 of the 10ft posts that are cut at the 40% angle on a level surface

Ensure the cut angle is facing the same way on both posts and that the 19mm holes (about
halfway up) are facing outwards

Now place the 1274mm 4”x4” post between the 2 larger posts

Line up the markings as shown below