Specifications / Features
Power Output
5 x 200W RMS @ 8ohms THD+N <0.05% - all
channels driven simultaneously
Peak Power 300W into 8ohms any individual
channel
Frequency re/-0.5dB 20-20kHz
Dynamic range 100dB A-weighted @ full power
IM distortion (CCIF) 0.001%
TIM distortion 0.01%
Soft Clipping
NHTBus Features
Intelligent operation with NHT Controller
Monitoring of amplifier status
Amplifier control – on/standby/mute
Control of individual channel operation – on/off
Utilizes Ethernet infrastructure
Protection features
Phase-to-phase short
Phase-to-ground short
Under voltage
Thermal protection
Rear panel connectors & components
5 Single-ended RCA input connectors
5 Pair of binding posts for speaker output –
banana spacing
12V Trigger input/output on 1/8” sub mini jacks
NHTBus connector on RJ45
IEC mains voltage socket
Front panel features
5 Dual-color LED’s for each channel indicating
OK/Fault
Standby Touch Sensor
Standby indicator
Placement
The Power
5
amplifier may be placed on a shelf, or in a
standard 19" equipment rack using the optional rack ears
and hardware.
Ideally, the Power
5
should be placed in close proximity to
the NHT Controller or surround processor. Minimizing
cable lengths reduces the chance of noise pickup.
Note: Due to the placement of the Power
5
power switch
on the rear panel, do not install the Power
5
in a wooden
box or similar enclosure where access to the power
switch is blocked or inconvenient.
6
