Quick Start Guide: BLUEBOARD-RL78/G12/G13/G14_30pin
Page | 10
4.2 Powering the Board
The BLUEBOARD-RL78/G12/G13/G14_30pin requires DC supply of 6.5V.1A rating to power it up,
alternatively the board could be powered through Emulator.
4.3 Verifying all the peripherals BLUEBOARD-RL78/G12/G13/G14_30pin board
The following section focusses on the verification of all the peripherals supported on the BLUEBOARD-
RL78/G12/G13/G14_30pin board. The order of the tests is mentioned in the same manners as the flow of
the test firmware. We highly recommend that you follow the order of the test. The test firmware is designed
in a manner that the user needs to spend as minimum time as possible to verify all the peripherals.
Note: It is highly recommended that the user tests all the peripherals as soon as the board is received.
Power up the board and we are all set to verify the BLUEBOARD-RL78/G12/G13/G14_30pin board
peripherals. The order of the peripherals that are verified by the firmware are as follows:
4.3.1 LED
Test setup and verification
:
As soon as the board is turned ON or reset; the test LED (D1) go ON & OFF for a couple of times, this
simple test validates the LED.
4.3.2 BUZZER
Test setup and verification
:
When the board is turned ON or reset you will hear a beep after few seconds. This confirms the status of
the Buzzer.
4.3.3 USER SWITCH
Test setup and verification
:
When you press the User Switch, LED (D1) toggles.