7
BEFORE YOU START:
The wine cellar should be placed in a location where the ambient temperature is between
32-100.4 degrees Fahrenheit. If the ambient temperature is above or below this range, the performance of the unit
may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to
fluctuate.
SETTING THE TEMPERATURE CONTROL
IMPORTANT: IN ORDER FOR THIS UNIT TO FUNCTION AT OPTIMUM LEVEL, THE LOWER COMPARTMENT
SHOULD BE SET AT LEAST 4-DEGREES (F) HIGHER THAN THE UPPER COMPARTMENT.
1. Make sure power cord is connected to a properly grounded outlet.
2. Turn Power ON.
3. Press the “SELECT” button to choose the “UPPER” or “LOWER” zone. Each zone is independently controlled.
Upper Zone:
The temperature setting can be adjusted between 41°F to 60°F
Lower Zone:
The temperature setting can be adjusted between 45°F to 64°F
4. Set the temperature of the UPPER or LOWER zone as you desire by pushing the
UP (+)
or
DOWN (-)
button.
When you push the two buttons for the first time, the LED readout will show the original temperature set at
previous time (the temperature preset at the factory is 41°F for Upper Zone and 45°F for Lower Zone).
5. The temperature that you desire to set will increase 1°F if you push the
UP(+)
button once, and alternatively will
decrease 1°F if you push the
DOWN (-)
button once.
7.
NOTE:
The desired temperatures may fluctuate depending on whether the interior light is ON or OFF and
depending on the orientation of the bottles.
6. Once you have set the desired temperature, wait 5 seconds. The temperature shown in the both UPPER and
LOWER zone display panels will automatically switch to show the actual temperature inside the unit. The actual
temperature will always be shown until the next time you press the UP (+) or DOWN (-) button to change the
temperature settings.
LIGHT:
Turns the interior Wine Cellar light on or off.
SELECT:
Allows user to select to control the UPPER or LOWER zone.
ON/OFF
: Turns the Wine Cellar on or off.
UPPER ZONE:
Adjusts and displays, via LED, the desired temperature (F) and the actual temperature (F) of the
UPPER zone.
LOWER ZONE:
Adjusts and displays, via LED, the desired temperature (F) and the actual temperature (F) of the
LOWER zone.
