10
11
How to Install
Accessories
Acidic water
outlet
How To Install
pH test kit
Diverter
Hose
Color chart
Manual
Tap water
Inlet
Installation Method - At the sink with a diverter
1. ATTACH DIVERTER TO YOUR TAP - Remove the aerator from tap (pliers may be required), and attach
diverter valve in its place. There are adapters supplied in case the diverter does not fit your tap.
If you have leaks at the diverter, use plumber's Teflon tape. (Image No. 3)
(We are now including Teflon tape in ionizers. Please use this.).
1
2
3
Use a Teflon tape
Inlet hose
(PE hose)
Inlet Fitting(1/4”)
2. ATTACH THE WHITE TAP WATER INLET HOSE - Attach one end of the white hose to the gray port
on the bottom of the ionizer labeled "TAP WATER INLET" .
To attach the white hose, simply push it firmly into the
opening on grey port.
(If you need to remove it, press on the end of the fitting
while pulling out).
3. ATTACH THE GRAY ACIDIC WATER OUTLET HOSE
- to the white plastic port labelled ACIDIC WATER
OUTLET on the bottom of the ionizer. First, slide
a squeeze clamp over the end of the hose.
Then attach the gray hose, by simply pushing it
firmly over the white plastic port. Soaking it in hot
water for 30 seconds will make attaching it very easy.
Squeeze the clamp and position it over the white port.
Ensure the opposite end runs into the sink.
5. POSITION YOUR IONIZER - Ensure it is on a hard and level surface.
A wall mount can be done - there are keyhole slots on the back for this.
6. ATTACH THE WHITE HOSE TO THE DIVERTER - Remove the small compression nut on
the back of the diverter (opposite of the lever).
Slide the nut over the opposite end of the white hose
you attached to the TAP WATER INLET port with the
threads positioned so it will screw it back onto the
diverter. Push the hose firmly onto the nipple, then
screw the compression nut back on.
Ensure the nut is screwed firmly in place, but do
not over tighten.
7. CONNECT THE POWER CORD to an appropriate GFI outlet.
8. INSTALL FLEXIBLE STAINLESS STEEL SPOUT
- Screw this into the threaded port on the top of the ionizer. Do not over tighten.