20
21
How to replace the filter
IMPORTANT! Stop water flow prior to filter replacement.
When the digital filter life indicator reaches full
or you see the flickering filter symbol,
it is time to replace your filter.
1
Open the filter housing cover.
2
3
Remove the expired filter.
-Taking hold of the filter securely with you right hand, press the
filter firmly down against the spring loaded mechnism to disengage
the top of the filter and then lean the filter out toward you and lift up
to remove it.
-The upper part of the filter is separated from housing by pressing
firmly down. Once you have engaged the spring loaded mechanism,
you can then easily remove the filter from the main body by
leaning the filter out toward you and life up to remove it.
4
Insert the new filter into the compartment.
-Remove the plastic caps covering both ends of the new filter.
-Seat the large opening on the bottom of the filter cartridge onto the base.
-Push the filter down and into the housing compartment ensuring the opening at the top
of the filter is seated properly into the fitting at the top of the housing.
5
6
7
8
Flush out the GAC carbon dust.
Reset the filter life indicator.
Replace the filter housing cover.
Press the Alkaline button
about 3 seconds
Press the Acidic button
about 3 seconds
1st Filter Life
2nd Filter Life
NOTE : This procedure is the same for both filters
-Push in on the plastic ridges in the center of the
filter housing cover on the side while pulling the
door out and to the left. Swing door out and remove it.
Check the leaks by running water through your ionizer before replacing the
housing cover.
-The water will initially come out discolored(light to charcoal gray) due to carbon dust
in the new filter. This is not harmful and is typical of all GAC filters.
Allow the water to flow for 2-3 minutes in the “Filtered” mode and this will flush all the
carbon dust.