Nexus 21 L-45en, Installation Instructions Manual

Page: 23 / 32

23
Tapered Pins
Step 25: Remove Cabinet Lid and drill two holes in
the marked positions.
Use a 7/32” drill bit to drill two
holes, ½” deep, in the underside of the Cabinet Top
where you have marked.
Step 26: Using a Phillips head screw driver
(not
provided) screw each Tapered Pin into the holes
drilled in step 25.
Step 27: Place the Cabinet Lid onto the Lift System. Align the Tapered Pins with the 2 holes in the Top Plate
Bracket and put the Lid on. Tighten the nuts on the underside of the hole where the Tapered Pins pass
through the Top Plate.
NOTE: You will have a ¼” tolerance (in all directions) for the placement of the Tapered Pins into your cabinet
lid. There are a set of nuts on the underside of the Top Plate that allow you to adjust the position of the hole
that the Tapered Pins will pass through to secure the cabinet lid to the Top Plate. If you happen to position the
Tapered Pins a few millimeters off from your intended position, you can still make adjustments to fit properly.