Nexus 21 L-23S, Installation Instructions Manual

Page: 17 / 24

17
Tapered Pins
How to Install the Tapered Pins:
You will be screwing the Tapered Pins into the UNDERSIDE of your cabinet lid, and they will hang down and
drop into the two holes in the Top Plate (Part #8).
Step 17: Before installing the Tapered Pins, position the Cabinet Lid. With the TV and the Lift System in the
fully DOWN position, set the Cabinet Lid in place. It will not be attached at this point, so move it around on the
Top Plate, making sure it fits centered in the cabinet opening.
Step 18: Run the Lift System up and down with the Cabinet Lid sitting on top, but not attached. Without
bumping
the Cabinet Lid out of place, use the Remote Control Handset to send the Lift System up and down. Make sure
that when the Lift comes down, the Cabinet Lid drops into the proper position relative to your cabinet
opening. Note: You may want to temporally tape your lid, to prevent the lid from shifting.
Step 19: Mark the spots for the Tapered Pins. Again,
without bumping the Cabinet Lid out of place, run the
Lift System all the way UP, with the Cabinet Lid sitting
on top. Look at the UNDERSIDE of the Top Plate, find
the two holes, and use a felt-tip pen or a pencil to mark
the position of the holes on the underside surface of the
Cabinet Lid
.
Step 20: Remove Cabinet Lid and drill two holes in the
marked positions. Use a 7/32” drill bit to drill two holes,
½” deep, in the underside of the Cabinet Top where you
have marked.
Step 21: Using a Phillips head screw
driver (not provided) screw each
Tapered Pin into the holes drilled in
step 16.