NextWave Digital TDR-3200, Operating Instructions Manual

Page: 10 / 40

10
The following diagrams detail the most common ways of connecting the STB to your equipment.
Please Note: RF OUT, COMPOSITE(RCA), S-VIDEO, RGB or Component (Y,Cb,Cr) signlas are available at all times. Pluging in
to one socket does not deactivate the others. However, Component Out (Y, Cb, Cr) and RGB Out are only available via TV
SCART and have to be selected in the Video Configuration Menu. See page 24 for details.
1. Connect the coaxial cable from the
VHF/UHF Antenna to the AERIAL
socket on the rear panel of the STB.
3. Connect the SCART lead between
the main SCART socket on the TV
and the TV SCART socket on the
rear panel of the STB.
Connecting to a TV
Connecting to TV with SCART Input
Please Note: To accept the RGB signal, you may have to
enable SCART(RGB/Y,Cb,Cr) on your Television.
1. Connect the cable from the
Antenna to the AERIAL socket on
the rear panel of the STB.
2. Connect an RCA cable to
the VIDEO OUT socket on the
STB and the VIDEO-IN RCA
socket on your TV.
3. Connect an RCA cable to the
AUDIO OUT (L-R) socket on the
STB and the AUDIO IN (L-R) RCA
socket on your TV.
Please Note: If your TV set has S-Video inputs, better picture qulaity
can be achieved by using this connection.
SCART
S-Video
Composite Video (RCA)
1. Connect the VHF/UHF Antenna to the
AERIAL socket on the rear panel of the
STB.
2. Connect the S-Video lead between the
main S-Video socket on the TV and the
S-Video socket on the rear panel of the
STB.
3. Depending on your audio needs, link
audio output from any one of the three
types of audio connections.
Installation