8
GET OFF ALWAYS FROM THE REAR OF THE VEHICLE IN ORDER TO AVOID RISKS OF LOSING
CONTROL OF THE VEHICLE AND FALLING.
PROTECTION FUNCTIONS
The following anomalies could cause the protection functions of the hoverboard activation.
During use, if the system notes the presence of errors or the loss of balance, it will warn the user of these
anomalies, through control lights and intermittent alarm sounds.
- Driving on slopes with a gradient of more than 10 percent.
- Too low voltage of the battery.
- Excessively high speed.
- Exhausted battery.
- Oscillation forwards and backwards for more than 30 seconds.
If the system goes into protection mode, the alarm sensors switch on and the control lights start to sound.
THE HOVERBOARD WILL TURN OFF AUTOMATICALLY IN THE FOLLOWING CIRCUMSTANCES:
- The system detects a too high inclination, in any direction.
- In case of locking wheels for at least 2 seconds.
- In the event of activities which involve a significant consumption of energy (lengthy climbs, particularly
steep descents).
- If during use, the platforms are inverted or tilted beyond a safe limit.
ALWAYS EFFECT DESCENTS BACKWARDS TO AVOID FALLING OR LOSING CONTROL OF THE
VEHICLE
Driving the hoverboard in the abovementioned circumstances can damage the vehicle and injure the user.
In the event of the vehicle automatically switching off, the system will block the vehicle. Unblocking is made
manually by pressing the ON/OFF button on the back.
CALIBRATING FUNCTIONS
In the event of incorrect functioning it could be necessary to effect the calibrating process.
Make sure that the hoverboard is perfectly flat. Keep the ON/OFF button pressed until the LED lights will flash:
this means that the calibration has been effected successfully.
• MAINTENANCE
Make sure that the power cable is disconnected and that the hoverboard is off before proceeding.
Clean the external shell of the hoverboard with a soft and dry cloth.
The hoverboard is spray resistant, but cannot be immersed in water.
Do not allow water or other liquid to get inside the hoverboard, as this could cause permanent damage to
the electronic circuitry.
Clean the hoverboard after every use and do not store in a dusty environment.
• CONSERVATION
Before storing the hoverboard make sure that the battery is completely charged.
Charge the battery completely as this will prevent it from becoming completely exhausted over time.
Per long periods of time remove the battery and run it down /recharge it every three months.
Cover the hoverboard with a cloth. Dust and sand could get into the engine and damage it.
Store indoors, at a dry and suitable temperature. It is recommended to store the hoverboard in its original
packing or to cover it with a cloth.Dust could damage its internal components.
ANY ATTEMPT TO REPAIR OR AMEND THE HOVERBOARD AND ALL TAMPERING WILL RESULT
IN THE AUTOMATIC CANCELLATION OF THE WARRANTY.
The images and schemes in this manual are only included for illustrative purposes.
Garlando s.p.a. reserves the right to modify data, design, technologies and components without prior notice.
W A R N I N G S
W A R N I N G S
Summary of Contents for Skylon 6.5
Page 9: ...9 ...
