OWNER’S INSTRUCTIONS
Rechargeable 3-in-1
Quick-Connect Light Kit
Model NT-LS002373
The NextLED innovative 3-IN-1 Quick Connect Light Kit includes
a 320/140 Lumen Flashlight, a 400/160 Lumen Slim Bar Foldable
Light, a 120/70 Lumen Flex-Shaft Light and a USB Charging
Cord. All 3 lights are all interchangeable so you can pick the perfect
light that best suits the specific working circumstances. Keep this
manual for the safety warning and precautions, assembly, operating,
inspection, maintenance and cleaning procedures. Keep this
manual and the receipt in a safe and dry place for future reference.
CAUTION:
Read all instructions and warnings before operating!
SAVE THESE INSTRUCTIONS!
WARNING:
To avoid serious injury or death from electrical shock or fire:
1. This fixture
MUST ALWAYS BE USED IN ACCORDANCE WITH
ALL ELECTRICAL AND SAFETY CODES AND ORDINANCES
,
including the most recent National Electric Code (NEC) and with
the Occupational Safety and Health Act (OSHA) Volume 1 on
General Industry Standards and interpretations.
2.
ALWAYS
make certain that the power source conforms to the
requirements on the fixture.
3.
DO NOT
inspect or service the fixture while charging.
4. Do not charge for longer than 4 hrs. Overcharging will cause
overheating and shorten battery life.
5.
CAUTION:
Keep dry. Do not open, drop, short-circuit, incinerate,
expose to temperatures higher than 140ºF, or charge/use
if damaged.
6. People with pacemakers should consult their physician(s) before
use. Electromagnetic fields in close proximity to heart pacemaker
could cause pacemaker interference or pacemaker failure
7. This fixture is not explosive-proof,
DO NOT
use in potentially
dangerous locations, such as in flammable or explosive
atmospheres.
8.
NEVER
operate the light with the clear protective glass
broken or removed
.
9.
NEVER LOOK DIRECTLY INTO LIGHT SOURCE.
LED’s are
extremely bright and can damage eyes with prolonged exposure.
10.
KEEP AWAY
from heating vents, radiators, or other sources of heat.
11.
KEEP OUT OF REACH OF CHILDREN.
12.
INTENDED FOR INDOOR AND OUTDOOR USE.
LITHIUM BATTERY SAFETY WARNINGS
LITHIUM BATTERIES STORE A LARGE AMOUNT OF ENERGY
AND WILL VENT FIRE OR EXPLODE IF MISTREATED:
1. Keep work light dry.
2. DO NOT DO ANY OF THE FOLLOWING TO BATTERY PACK:
a. Drop
b. Open
c. Short-circuit
d. Puncture
e. Incinerate, or
f. Expose to temperatures greater than 140ºF.
3. Charge work light only according to these instructions
BATTERY REPLACEMENT
1. Unthread the base of the light.
2. Remove old battery, noting polarity
3. Insert a new 18650 type 3.7V, 1800mAh li-ion battery into the
light, positive end first
BATTERY CHARGING
WARNING: READ ENTIRE IMPORTANT SAFETY INFORMATION.
section at the beginning of this document including all text under
subheadings therein before set up or use of this product.
1. Insert the end of the charging cable into the charging jack,
located on the side of the handle, under a cover.
2. Plug charging cable into a powered USB port.
3. The charging indicator button will light up red during charging
.
After approximately 4 hours the charging indicator turns green
indicating that the work light is charged and ready for use.
Unplug the charging cable.
LIGHT ATTACHMENT AND FUNCTION
1. Attach the light of your choice to the top of the base by pushing
down on the light attachment to lock it in place
2. To remove the light attachment, pull down on the locking ring to
release the light attachment.
OPERATING INSTRUCTIONS
WARNING: READ ENTIRE IMPORTANT SAFETY INFORMATION.
section at the beginning of this document including all text under
subheadings therein before set up or use of this product.
NOTE: before using work light for the first time, fully charge
the battery.
Slim Bar Light:
1. Press the button once to turn on the light (160 Lumen)
2. Press the button again to switch to high mode (400 Lumen)
3. Press the button a third time to turn off the light
Flashlight:
1. Press the button once to turn on the light (140 Lumen)
2. Press the button again to switch to high mode (320 Lumen)
3. Press the button a third time to turn of the light
Flex-Shaft Light:
4. Press the button once to turn on the light (70 Lumen)
5. Press the button again to switch to high mode (120 Lumen)
6. Press the button a third time to turn of the light
ONE YEAR LIMITED WARRANTY
I
f this Smart Electrician
®
product fails due to a defect in materials
or workmanship, Smart Electrician
®
will at its option, repair it or
replace it with the same or comparable model, free of charge.
For repair or replacement under warranty, return to the retail
establishment where the product was purchased.
This warranty give you specific legal rights and you may have other
rights that vary from state to state.
This warranty is void if damage or defect has resulted from accident,
abuse, misuse or faulty repair. In no event will Smart Electrician
®
be
liable for any consequential, special, incidental, or indirect damages
of any kind arising out of the use or misuse of this product.
Maximum liability shall not in any case exceed the purchase price
of the product including shipping. Some states do not allow the
exclusion or limitation of incidental or consequential damages so
the above exclusions or limitations may not apply to you.
Rechargeable 3-in-1
LED KITS WITH INTERCHANGEABLE LIGHT HEADS
