[French: Afin de se conformer aux exigences d’exposition
RF ISED:
1. L’antenne du donneur doit être installée pour
fournir une séparation d’au moins 65 cm du
corps humain en tout temps.
2. L’antenne du serveur doit être installée pour
fournir une séparation d’au moins 20 cm du
corps humain en tout temps.
The Manufacturer’s rated output power of this equip-
ment is for single carrier operation. For situations
when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where
the output signal is re-radiated and can cause interfer-
ence to adjacent band users. This power reduction is to
be by means of input power or gain reduction and not
by an attenuator at the output of the device.
[FRENCH: La puissance de sortie nominale indiquée
par le fabricant pour cet appareil concerne son
fonctionnement avec porteuse unique. Pour des
appareils avec porteuses multiples, on doit réduire la
valeur nominale de 3,5dB, surtout si le signal de sortie
est retransmis et qu’il peut causer du brouillage aux
utilisateurs de bandes adjacentes. Une telle réduction
doit porter sur la puissance d’entrée ou sur le gain, et
ne doit pas se faire au moyen d’un atténuateur
raccordé à la sortie du dispositif.]
1. This device may not cause interference.
2. This device must accept any interference, in-
cluding interference that may cause undesired
operation of the device.
[French: L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développe-
ment économique Canada applicables aux ap-
pareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage ra-
dioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionne-
ment.]
CAN ICES-3 (A)/NMB-3(A)
Compliance Contact
In the event of regulatory compliance issue, please
contact Nextivity Inc. directly. Contact information is
available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US patents
and patents pending. Please refer to cel-fi.com for
details.
Copyright
Copyright © 2022 by Nextivity, Inc. All rights reserved.
Reproduction or media conversion by any means is
protected by copyright and may only occur with prior
written permission of Nextivity. Designed by Nextivity
in California.
Trademark
Cel-Fi and the Nextivity logo are trademarks of Nex-
tivity, Inc.
If you need help, visit: www.cel-fi.com/support.
legal_solo-red_classB_eng_22-0314
legal_solo-red_classB_eng_22-0314
Nextivity UK Ltd
Unit 9, Basepoint Business Centre Rivermead Drive, Westlea Swindon SN5 7EX
Nextivity Singapore Pte. Ltd.
2 Changi Business Park Avenue 1, Level 2 – Suite 16, 486015 Singapore
Bureau in Europe Union
Carrer Bassols 15-1, Bacelona 08026, Spain
Nextivity UK Ltd
Unit 9, Basepoint Business Centre Rivermead Drive, Westlea Swindon SN5 7EX
Nextivity Singapore Pte. Ltd.
2 Changi Business Park Avenue 1, Level 2 – Suite 16, 486015 Singapore
Bureau in Europe Union
Carrer Bassols 15-1, Bacelona 08026, Spain
Nextivity Inc.
16550 West Bernardo Drive, Bldg. 5, Suite 550
San Diego, CA 92127
www.cel-fi.com
Nextivity Inc.
16550 West Bernardo Drive, Bldg. 5, Suite 550
San Diego, CA 92127
www.cel-fi.com
420N007-L41-001-11R
C
420N007-L41-001-11R
C
1.
The donor antenna must be installed
to provide at least 65 cm separation
from the human body at all times.
2.
The server antenna must be installed
to provide at least 20 cm separation
from the human body at all times.
This
device
contains
licence-exempt
transmitter(s)/ receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two con- ditions:
ISED STATEMENT
WARNING
: This is
NOT
a
CONSUMER
device. It is de-
signed for installation by an installer approved by an
ISED
licensee. You
MUST
have an
ISED LICENCE
or
the express consent of an
ISED
licensee to operate
this device.
This device may operate in a fixed l ocation only, for
in-building use.
In order to comply with ISED RF Exposure require-
ments:
[French: Afin de se conformer aux exigences d’exposition
RF ISED:
1. L’antenne du donneur doit être installée pour
fournir une séparation d’au moins 65 cm du
corps humain en tout temps.
2. L’antenne du serveur doit être installée pour
fournir une séparation d’au moins 20 cm du
corps humain en tout temps.
The Manufacturer’s rated output power of this equip-
ment is for single carrier operation. For situations
when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where
the output signal is re-radiated and can cause interfer-
ence to adjacent band users. This power reduction is to
be by means of input power or gain reduction and not
by an attenuator at the output of the device.
[FRENCH: La puissance de sortie nominale indiquée
par le fabricant pour cet appareil concerne son
fonctionnement avec porteuse unique. Pour des
appareils avec porteuses multiples, on doit réduire la
valeur nominale de 3,5dB, surtout si le signal de sortie
est retransmis et qu’il peut causer du brouillage aux
utilisateurs de bandes adjacentes. Une telle réduction
doit porter sur la puissance d’entrée ou sur le gain, et
ne doit pas se faire au moyen d’un atténuateur
raccordé à la sortie du dispositif.]
1. This device may not cause interference.
2. This device must accept any interference, in-
cluding interference that may cause undesired
operation of the device.
[French: L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développe-
ment économique Canada applicables aux ap-
pareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage ra-
dioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionne-
ment.]
CAN ICES-3 (A)/NMB-3(A)
Compliance Contact
In the event of regulatory compliance issue, please
contact Nextivity Inc. directly. Contact information is
available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US patents
and patents pending. Please refer to cel-fi.com for
details.
Copyright
Copyright © 2022 by Nextivity, Inc. All rights reserved.
Reproduction or media conversion by any means is
protected by copyright and may only occur with prior
written permission of Nextivity. Designed by Nextivity
in California.
Trademark
Cel-Fi and the Nextivity logo are trademarks of Nex-
tivity, Inc.
If you need help, visit: www.cel-fi.com/support.
1.
The donor antenna must be installed
to provide at least 65 cm separation
from the human body at all times.
2.
The server antenna must be installed
to provide at least 20 cm separation
from the human body at all times.
This
device
contains
licence-exempt
transmitter(s)/ receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two con- ditions:
ISED STATEMENT
WARNING
: This is
NOT
a
CONSUMER
device. It is de-
signed for installation by an installer approved by an
ISED
licensee. You
MUST
have an
ISED LICENCE
or
the express consent of an
ISED
licensee to operate
this device.
This device may operate in a fixed l ocation only, for
in-building use.
In order to comply with ISED RF Exposure require-
ments:
