Support
North America:
+1-888-585-7059
CALA:
+1-970-382-4681
EMEA:
+44 (0) 845-843-7333
APAC:
Hong Kong: +852 2797 5678
|
Singapore: +65-68266099
© 2013 Verint Video Intelligence Solutions. All Rights Reserved Worldwide.
All other trademarks and product names are the property of their respective owners. Revision: A06
Using SConfigurator
►
To discover the device using SConfigurator:
1. Download the latest version of SConfigurator
(
http://verint.com/solutions/video-situation-
intelligence/resources/index
).
2. Open SConfigurator.
3. Select the
Units
tab, then click
Discover
.
4. Select the Nextiva IP camera model, and click
Configure
.
5. In the tree view, click
Network >
IP
.
6. Select
Use the following IP address
.
7. In the
IP Address
box, type the IP address for the
IP camera.
8. In the
Subnet Mask
box, type the address
specifying the subnet in which the IP address
belongs.
9. In the
Gateway
box, type the IP address of the
server that acts as an access point to another
network.
NOTE:
You do not need to use a gateway if the IP
camera communicates with other devices on
the same subnet.
10. In the
Host Name
box, type a unique name for the
IP camera.
11. Click
OK
to close the dialog box.
12. Click
Exit
to close SConfigurator.
Adding to EdgeVR
For complete information, refer to Technical Note:
TN529 Integrating Nextiva IP Cameras with EdgeVR.
►
To add to an EdgeVR:
1. Open the
Auto Config Cameras
page
■
From Vid-Center, click Setup DVRs in the Task
Center pane, and then double-click Auto Config
Cameras in the Task Actions pane.
■
From Vid-Center Embedded, click Setup/
Admin, double-click Auto Config Cameras.
■
From the EdgeVR Setup menu, double-click
EdgeVR Setup, go to page 3, then double-click
Auto Config Cameras.
2. In the editable
IP
boxes, type the numerical
representation of the remaining octets of the IP
address you want to assign to the device.
NOTE:
The number of configurable octets depends on
the subnet mask where the camera has been
discovered.
3. From the
Camera Num
list, assign a camera
number.
4. Click
OK
.
5. In the
Camera Setup
page, verify that all the
information is correct.
Adding to Nextiva VMS
For complete information, refer to Technical Note:
TN700 Verint IP Camera Integration in Nextiva VMS.
►
To add to Nextiva VMS:
1. Launch Nextiva Control Center.
2. Using the System Setup Wizard in Control Center,
assign the camera to physical and logical groups.
3. View the Physical Settings for the camera.
4. Define a Video Profile if the camera introduces
high resolutions.
5. Assign the camera to a Recording Profile.
6. View and configure the Logical Settings for the
camera.
7. Configure the camera in Nextiva VMS Virtual
Matrix if you are adding it to a tour or salvo.
8. Add the camera to a Nextiva VMS Event Manager
scenario in order to trigger an automatic response
for an event recorded by the camera.