1. Slide panel 10 into the assembled unit as shown in
diagram.
1.Insert 18 × cambolts (A) into panels 1, 2 & 3 and using
a screwdriver until tight.
2. Attach push & out (H) on panel 3 with 2 x screws(H)
provided on pre-drill hole position as shown in diagram.
3. once push & out (H) are correctly adjusted then
fasten with 2 x screws(H) on the remaining holes in the
push & out (H) .
STEP ELEVEN
STEP TWELVE
push & out (H) .
1. Glue (E) and insert 3 x wooden dowels (C) into panels
4, 5 & 6 and attach panel 1 to panels 4, 5 & 6.
2. Insert 6 x camlocks (B) into panels 4, 5 & 6 and tighten
with a screwdriver.
Ensure the arrow indicator is pointing towards the panel
edge and ensure the assembly bolt locates properly into
the camlock before turning
STEP THIRTEEN
Page 6 of 10
