Next Wave Automation CNC Shark HD4, Using Manual

Page: 4 / 8

September 2018 Laser Engraving Guide | 4
Highlight image and Select Quick Engrave from Toolpath
Select Any Engraving Bit
•
Spindle Speed = Laser Power
•
Valid Values for Spindle Speed (ipm= inches per minute) for laser engraving purposes, are 1000
through 0. For full power type
in “ 1000 ”. Zero means the laser is “off”.
•
Feed Rate is dependent on wood density. The denser the wood, the slower the Feed Rate. A
good rule of thumb is
to type in “ 40 ” ipm. If you would like to run the laser on cardboard for a
test, use “ 100 ” ipm for the Feed Rate. Note: You can use the feed rate over ride on Pendant
later to also adjust your speed)
•
Select “ OK ”