April 2018
CNC Piranha FX/XL | 10
•
CNC Controller
•
15 pin LCD Pendant Cable
•
Touch Screen Pendant
•
Power Supply
•
Power Cord
•
2 Hold Down Clamps
•
Router ON/OFF Controller (Available Piranha XL Only)
Make sure when removing the CNC Piranha FX/XL from its box that you lift it from the base,
lifting it by the gantry or table can cause misalignment.
WARNING
:
The axis cable connectors should never be disconnected or re-connected while
there is power to the Controller Interface. Doing so can damage the stepper driver board
inside the Controller Interface.
Install Router into Router Base by loosening the hold down clamp and sliding the Router in until
the motor protrudes about 1 ½” below the clamp.
CNC Piranha FX/XL Router Mounting
Tighten all clamping bolts securely.
Summary of Contents for CNC PIRANHA Fx
Page 1: ......
