WARNING
Do not try lighting this appliance without reading the
“LIGHTING INSTRUCTIONS” section of this manual.
Grill Installation Codes
The installation must conform with local codes or, in the
absence of local codes ,with either the national fuel gas
code ,ANSI Z 223.1/NFPA 54,Natural gas and Propane
installation code, CSA B149.1,or Propane Storage and
Handling Code,B149.2, or the Standard for Recreational
Vehicles, ANSI A 119.2/NFPA 1192,and CSA Z240 RV
series Recreational Vehicle Code, as applicable.
Correct LP Gas Tank Use
LP gas grill models are designed for use with a standard
20 lb. Liquid Propane Gas tank, not included with grill.
Never
connect your gas grill to an LP gas tank that
exceeds this capacity.
If an external electrical source is utilized
: The outdoor
cooking gas appliance, when installed, must be
electrically grounded in accordance with local codes or, in
the absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
WARNING
Keep any electrical supply cord and the fuel supply hose
away from any heated surfaces.
NOTE
: The normal flow of gas through the regulator and
hose assembly can create a humming noise. A low
volume of noise is perfectly normal and will not interfere
with operation of the grill. If humming noise is loud and
excessive you may need to purge air from the gas line or
reset the regulator excess gas flow device. This purging
procedure should be done every time a new LP gas tank
is connected to your grill.
CAUTION: Beware of Flashback
CAUTION:
Spiders and small insects occasionally spin
webs or make nests in the grill burner tubes during
transit and warehousing. These webs can lead to gas
flow obstruction, which could result in a fire in and
around burner tubes. This type of fire is known as
“FLASH-BACK” and can cause serious damage to
your grill and create an unsafe operating condition for
the user.
Although an obstructed burner tube is not the only
cause of “FLASH-BACK”, it is the most common
cause.
To reduce the chance of “FLASH-BACK”, you must
clean the burner tubes before assembling your grill,
and at least once a month in late summer or early fall
when spiders are most active. Also perform this burner
tube cleaning procedure if your grill has not been used
for an extended period of time. A clogged tube can be
lead to a fire beneath the grill.
Visually check the burner flames prior to each
use, the flames should look like this picture, if
they do not ,refer to the burner main tenancy
part of this manual.
PRECAUTIONS
TESTED IN ACCORDANCE WITH ANS Z21.58a •
CSA 1.6a-2006 STANDARD FOR OUTDOOR
COOKING GAS APPLIANCE. THIS GRIL IS FOR
OUTDOOR USE ONLY.
I15Y06P-1
2
