Nexersys Fast Fists, Owner'S Manual

Page: 32 / 46

29
Fast Fists Owner’s Manual
My Fast Fists is Not Turning On
The red light on the power switch does not turn on
Both the monitor and CPU require power. Check that both the monitor and CPU power cables are inserted
properly, that your Fast Fists is plugged in, and that the power cable is securely connected to the AC power
brick.
The red light on the power switch turns on but nothing happens
Check that the monitor’s power and video cables are connected properly. Also make sure that the monitor is
on. Check that the green light on the left side of the monitor is lit to indicate the monitor is ON.
Ensure that the card is inserted into the CPU properly.
After turning your Fast Fists on, it will need at least 20 seconds to boot up before you will see activity on the
screen.
Aggregator and Accelerometer Bootload
The computer must program each accelerometer when the Fast Fists iPower Trainer is first powered on. This
process is called bootloading. You may receive an error message during the bootload process that identifies
an accelerometer is not connected – or the bootload process may stop (i.e. hang). Please turn off the CPU,
check the connection of any reported pad error, and then restart the CPU.
The pad layout corresponding to the accelerometer numbers is shown below:
Please don’t hesitate to contact Fast Fists support if you have any questions.
Troubleshooting