Zigbee DALI TW Converter with power supply
￭
If multiple circuit breakers supply dangerous voltages to the device or load, couple the
miniature circuit breakers or label them with a warning, to ensure disconnection is guaran-
teed.
￭
Make the connection according to the connection diagram. In doing so, note the clamp-
able conductor cross-section (Figure 3).
￭
Use the correct outputs when connecting DALI DT6 luminaires DT6-1 = cold white (cw),
DT6-2 = warm white (ww).
￭
Fit a strain relief (4) on the input and output side and snap on the cover caps (5)
(Figure 1).
￭
Perform commissioning.
The light can be switched by briefly pressing the Prog. button.
7
Commissioning with app
The requirement for commissioning via app is a mobile end device (smartphone, tablet) with
Bluetooth interface, running the Android or iOS operating system. The app guides you step by
step through the commissioning process.
￭
Download and install the NEXENTRO Config App from the App Store (iOS) or Google
Play Store (Android).
App functions
–
Joining an existing network
–
Setting up your own network
–
Assigning device names
–
Setting device parameters: minimum brightness, warmest and coldest colour temperature
–
Connecting the actuator with Zigbee transmitters or gateways
–
Connecting the input to Zigbee devices
–
Indication of the switching status: On, Off, brightness value and colour temperature
–
Displaying device information: Device type, software version, hardware version
–
Performing a software update
–
Resetting to default setting
–
Operating the actuator for test purposes
Coupling and registering new devices
The coupling of new devices is always possible for approx. 1 minute after mains voltage
return to prevent unauthorised access. Coupling is possible at any time with devices re-
gistered in the app.
￭
Couple the end device via Bluetooth with the device.
￭
Add the new device to the list of registered devices.
￭
Assign a device name.
Performing Zigbee configuration
The actuator can be added to an existing Zigbee network to control the Zigbee devices present
there or to be controlled by transmitters present there.
If no Zigbee network exists, the actuator can create its own Zigbee network by calling it in the
app.
Adding an actuator to the Zigbee network of a gateway
With certain gateways, adding to a network is done via the Touchlink function.
￭
Start search mode for new devices in the Zigbee system. The function call depends on
the gateway, e.g. "Search devices".
￭
Select the Join Network function.
The actuator is displayed in the app of the gateway.
4 / 7
82403700
02.09.2020
