Copyright © 2017 NEXCOM International Co., Ltd. All Rights Reserved.
34
eLITE610 User Manual
Chapter 3: System Setup
Panel Mounting
1. Select a place on the panel where you will mount eLITE610.
2. Cut out a shape on the panel that corresponds to the rear dimensions
of eLITE610.
The thickness of the panel (e.g. steel board, plank, acrylic board, wall,
etc.) where you will mount eLITE610 must not exceed 6mm. If the
distance between the front bezel and panel mount hole is too wide, it will
not fit the panel mount kit.
271
18
6
6
CUT OUT SIZE = 6mm (MAX) / 1mm (MIN)
3. Slide eLITE610 through the hole until it is properly fitted against the
panel.
