......4
............4
4x25mm hex bolt
Blind-nut
4mm washer
............4
3x20mm screw
Nut
.............4
...4
Reposition the engine mount beams on to the fire-wall
and secure them with four 4x25mm hex bolt.
Insert the blind-nut onto each of the four holes make
above.
Position the engine to the engine mounts so the distance from the
prop hub to the fire-wall is
110mm
.
Mark the engine mounting plate where the four holes are to be drilled.
Remove the engine and drill a 3mm holes through the beam at each
of the four marks made above.
Marking sure that you drill the hole perpendicular to the beam of the
engine mount.
Reposition the engine on the engine mount beams, aligning it with
the holes. Secure the engine to the engine mount using four 3x25mm
hex bolts.
Note: Apply Silicon sealer to each of the
3x25mm bolt and nut.
110mm
Ensure that the fuel tank clunk does not touch
the rear of the fuel tank.
Checking for leaks - block the vents and blow
into the feed, if in doubt submersing the tank
in a blow of water will show up any problems.
Blow
Water
2
X
To muffler
Filler tube
To engine
3x35mm screw
Rubber stopper
1
After confirming the direction . Insert this
assembly, clunk end first, into the fuel tank
and tighten and screw the fuel tankcap on firmly.
17- Glow engine
continued
18- Fuel tank
(in case of glow engine using)
