23
L
N
Min 2.5
Min 2.5
E
Min 2.5
Cautions
The hob must be installed by qualified personnel or technicians. We have
professionals at your service. Please never conduct the operation by yourself.
The hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
The hob shall be installed such that better heat radiation can be ensured to enhance
its reliability.
The wall and induced heating zone above the work surface shall withstand heat.
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
A steam cleaner is not to be used.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker.
Warning: Connect the power cord to main power supply in accordance with the
instruction listed in the table below:
Wire cross-sectional
area(mm
2
)
Before the appliance being connected with the mains, please do assemble one full
polar breaker with over 2.5mm opened on the mains, and the rated current of the
breaker is strongly recommend over 27A.
If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.
If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.
The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.
The cable must not be bent or compressed.
The cable must be checked regularly and only replaced by a proper qualified