Newworld 100DFT, Users Manual & Installation Handbook

Page: 9 / 44

Ignition
Push in and turn the selected control
knob anticlockwise to the ‘full on’ posi-
tion and press the ignition switch, or
hold a lighted match or taper to the
burner, until the burner lights.Hold the
control knob in for 15 seconds. Do not
hold the control knob in for longer
than 15 seconds. If the burner faills to
light within this time, release the contol
knob and wait for one minute before
attempting further ignition.
Turn the control knob to the required
setting.Adjust the burner flame so that
it does not extend over the pan base.
To turn off, push in the control knob
and turn clockwise until the dot on the
control knob is below the line on the
facia panel.
To simmer
The simmer position is marked by the
small flame symbol.
Once lit turn the selected control knob
anticlockwise past the large flame symbol
(full on) to the small flame symbol.
You may hear a slight popping noise
when the hob burners are operating
and this is quite normal, but if anything
about the cooker appears unusual,
such as change in flame appearance,
or the operation of controls - seek
expert advice.
Pans
For optimum safety and performance,
we recommend the use of flat bottomed
pans with a base diameter of minimum
100mm (4”) and maximum 250mm
(10”).
Avoid using old misshapen pans or
any pan which is unstable when
placed on a flat surface.
Turn pan handles to a safe position
so they are out of reach of children,
not overhanging the appliance and
cannot be caught accidentally.
Position pans over the centre of the
burners, resting on the pan supports.
If positioned off centre, smaller pans
may be unstable.
When cooking with fat or oil, never
leave unattended.
Commercial simmering aids should
not be used as they create excessive
temperatures that can damage the
surface and may cause a hazard.
When you have finished
cooking check that all controls
are in the off position.
Pan supports
Make sure that you use the correct
shaped pansupport for the burner you
wish to use.
The wok burner has a different shaped
pan support to the other hot plate burn-
ers. The wok burner must only be
used with this pan support
7
Using the Hob