Safety Regulations
User Manual for AZ110 Broadcast Satellite Modulator with ASI interface
version 3.2
v
SHAPING THE FUTURE SATELLITE OF COMMUNICATIONS
SAFETY REGULATIONS
Please read this chapter before you install and use this equipment.
To ensure your safety, the equipment has been designed to comply with the
following safety standard:
IEC 60950 Safety of Information Technology Equipment
Before you start to install and operate the device, please make sure you observe
the following points:
•
The equipment described in this manual is designed to be used by properly
trained personnel only. Only qualified personnel who are aware of hazards
involved involved shall carry out adjustment, maintenance and repair of the
exposed equipment.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock, do not remove covers.
•
To use the equipment correctly and safely, it is essential that both operating and
servicing personnel follow generally accepted safety procedures in addition to
the safety precautions specified in this manual. Warning and caution
statements and/or symbols are marked on the equipment when necessary.
•
Whenever it is likely that safety protection is impaired, immediately switch off
the equipment and secure it against unintended operation. Inform the
appropriate servicing authority about the problem. For example, safety is likely
to be impaired if the equipment fails to perform the intended measurements or
shows visible damage.
Caution 1:
FOR CONTINUED PROTECTION AGAINST FIRE, REPLACE
LINE FUSES ONLY WITH SAME TYPE AND RATING ( 5 X
20mm T3.15 A/250v TYPE T OR SLOW-BLOW);
Caution 2:
THERE IS RISK OF EXPLOSION IF THE BATTERY IS
REPLACED WITH AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
