RollMaster™ 1000
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St. Unit F, Aurora, CO 80011
T
800.624.6706
F
303.364.7796
•
Newstripe.com
RollMaster™ 1000 Manual / 3856.0917
Assembly for Striping
1.
Apply a light coat of grease to the “O” ring and the short end of the Mandrel Tube. Insert the Mandrel Tube into the
open side of the Mandrel with the "O" ring side toward the Mandrel (Pic 6).
2.
Place the Mandrel with Roller Cover in the "J" hooks of the Carrier Assembly with the Mandrel Tube to the left side.
The washer attached to the Mandrel Tube will be on the inside of the "J" Yokes. The Mandrel should be able to slide
up and down in the "J" Yokes freely. If necessary, bend the side plates out just enough to allow the Mandrel to
move up and down freely (Pic 7).
3.
Open the Trough by grasping the Thumb Grip and the Rear Wheel hub and squeezing together (it will click and lock
open) (Pic 8).
4.
Slide one end of Paint Hose over the Mandrel Tube and insert the hose under the Pump Rollers and inside the Trough.
Squeeze the hose flat and insert it through the side of the Eye Bolt with the colored band ABOVE the Eye Bolt at the
top of the Trough. Close the Trough by pulling OUT on the release button located on the Trough (Pic 9).
5.
Make sure the Paint Hose is under the Pump Rollers and is not pinched by the sides of the Trough.
OPERATION
1.
Punch a hole in the can lid with the provided Punch about 1 inch from the left edge. A second SMALL "vent
hole" should be punched near the other hole.
2.
Insert the Paint Can Tube (1) into the punched hole.
3.
Attach the open end of the Paint Hose to the Paint Can Tube.
4.
When you squeeze the Control Lever, the Pump Drive Wheel is brought in contact with the Rear Wheel, and
paint is pumped directly to the Roller Cover. Release the lever and pumping stops.
NOTE: Only squeeze the Control Lever in forward motion. Release the lever when rolling backwards.
5.
Make sure the Trough is in the closed position.
6.
To prime the Roller Cover for painting, squeeze and hold the Control Lever. Tip the unit back slightly so the front
wheels are off the ground and roll the unit forward approximately 50-75 feet. You should see ‘dots’ of paint
forming on the Roller Cover. This indicates that the Roller Cover is priming properly with paint.
7.
Now place the unit on an existing line or cardboard and roll the unit forward and backwards with the front
wheels contacting the surface until the roller is completely saturated.
“O” Ring
“J” Yoke
Trough in open position
Trough in closed position
Pic 6
Paint hose
Thumb grip
Roller Carrier
Regulating
Disc
Pic 7
Pic 8
Pic 9
Page 3 of 8
Eye
Bolt
Summary of Contents for RollMaster 1000
Page 10: ......
