ECOLINER™
ALWAYS wear safety goggles or protective eye-wear when operating the unit!
1700 Jasper St., Unit F, Aurora, CO 80011
T
800.624.6706
F
303.364.7796
•
Newstripe.com
EcoLiner™ Manual / 4483.0917
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
REMEDY
Pump will not run
Battery not charged
Fuse blown
Fuse disconnected
Charge Battery
Change Fuse
Check fuse holder connection and wires
Pump will not prime
Pump or hoses may be restricted
Disconnect supply and discharge hoses. Clean
out hoses. Pour hot water into inlet opening of
pump and let soak. Reconnect hoses and start
pump again.
Pump still won’t prime
If hot water alone does not remove clog, pour
liquid dish soap or the “Simple Green” product
into the pump inlet. Jog the pump
(operate toggle switch briefly) to get the soap
into the pump and let it soak (15-30 minutes).
Attach hoses and try pumping water. If pump
start pumping, let it circulate on the water for
5-10 minutes before adding paint. The pump
does not need to be rinsed of the soap as the
soap will mix easily with the paint. If still not
working, call factory. Disassembly of pump will
VOID the warranty.
Paint leaving nozzle in
stream, not spray
Paint too thick
Thin paint.
Spray inconsistent
Obstruction in nozzle
Remove nozzle screen. Clean or Replace.
Spray inconsistent
Obstruction or clog in pick up tube
screen
Remove pick up tube and filter screen. Filter
paint, clean screen and remove clogs.
Spray pattern too thin
or uneven
Wrong nozzle or spray head height is
incorrect.
Viscosity may be too thick
See Selection Guide. Adjust spray head height
up or down. Nozzle slot has to be horizontal to
ground.
Thin paint as per manufacturer
recommendation
Paint drips after being
shut off
Dirty or worn check ball in nozzle or gun
filter
Faulty control lever
Dissemble and clean, or replace
Replace
Please call us!
If you have any questions during setup, painting or cleaning 1-800-624-6706
