AeroVent
®
3X
ALWAYS wear appropriate personal protective equipment when operating the unit
!
AeroVent® 3X Manual / 4721.0117
Page 2 of
7
ASSEMBLY
1.
Remove the 2” bung cap from an empty 30 or 55 gallon recovery drum.
Insert the threaded nipple of the AeroVent® 3X into the opening and
turn the unit until it is hand tight. Center the unit over the drum.
2.
Adjust the rear support feet clockwise until they are snug to the top of
the drum. Then, adjust the front support foot until it is tight to the rim of
the drum (the “chime”).
3.
Place the operating handle on the mounting plate so that the holes are
aligned. Insert one bolt (with washer) through each hole. Loosely install
one locking nut onto each bolt, but do not tighten yet. (Figure 1)
4.
Lower the operating handle so that the swivel foot is centered side-to-
side on the lid striker plate. Now tighten all nuts and bolts of the
operating handle assembly to the mounting plate. (Figure 2)
5.
Remove the 3/4” bung cap from the top of the recovery drum and thread
the Safe2Vent™ Dual Filter with Manifold into place. Hand-tighten
only!
Note:
Remove the plastic packaging completely before installing
the Safe2Vent™ Filter.
6.
Attach the clamp end of the grounding cable to a suitable
grounding source, such as a metal water pipe or grounding rod.
Included Parts:
AeroVent
®
3X unit with ground
cable
Safe2Vent
™
Dual Filter with
Manifold
Operating Handle
Operating Handle Hardware:
Bolts (4), Washers (4), Nuts (4)
2” Can Guide
Tools needed for assembly
:
(Not included)
(2) 1/2” wrenches.
Safe2Vent™
Dual Filter
w/Manifold
Operating
Handle
Handle
Hardware
2” Can
Guide
FIGURE 2
FIGURE 1
Mounting
Plate
Chime
Front
Support
Foot
