3’ Nail Drag with Wheel Kit
ALWAYS wear safety goggles or protective eye-wear when operating the unit
!
Step 2: Installing the upper clam shell.
A. Place upper clam shell (10) open side down into lower frame
section (2). Make certain holes in upper claim shell align with hole
in lower frame section.
Step 3: Installing the drag nails:
A. Lift end of lower frame section (2) to a vertical position.
B. Insert 17 drag nails (4) through holes in upper clam shell (10),
then through holes in lower frame section. NOTE: nails may
need to be tapped into place with hammer.
Step 4: Installing the retainer plate.
A. Insert 3/8-16 x 2 1/2 bolt (5) through 3/8 flat washer
(9) then through holes in retainer plate (1), Upper clam
shell (10) and lower frame section (2).
B. Place a 3/8 flat washer (9) and 3/8-16 lock nut (8) on
the bolt and tighten firmly.
C. Repeat steps A & B on remaining three holes.
Step 5; Repeat steps 2 - 4 for remaining cross member.
TOP VIEW
BOTTOM VIEW
COMPLETED ASSEMBLY
Page 3 of 4
Summary of Contents for 10002626
Page 1: ...3 Nail Drag with Wheel Kit Product Manual...
Page 2: ......
