3’ Nail Drag with Wheel Kit
ALWAYS wear safety goggles or protective eye-wear when operating the unit
!
Before assembling, please check the shipping
carton. You should have:
(2) Left Side Wheel Assembly
10004545
(2) Right Side Wheel Assembly 10004546
(8) 5/16-18 Lock Nut
10000406
(8) 5/16 Flat Washer
10000095
(8) 5/16-18x1 1/2 bolt
10002600
(4) Lynch Pins
10003211
Replacement Wheel
10000753
(Not Included)
Tools required for assembly
(Not included)
(2) 6” adjustable wrenches or 1/2” wrenches.
If the nail drag is not assembled, the wheel kit must be installed first
.
If the nail drag has been assembled, the front and rear
retainer plates and upper clam shells must be removed to
install the wheel kit.
Mount wash wheel assembly to the two holes, front and rear,
on each side of the nail drag. Use the 5/16" bolts, washers,
and nuts provided with the kit. The nuts and washers must go
to the inside of the frame. When properly installed the
handles should rotate forward so that the wheels trail behind.
IMPORTANT NOTE:
If the nail drag has not been previously
assembled, refer to step 1: Attaching chain in the nail drag assembly
instructions. You must combine step 1: Attaching chain with the
installation of the wheel kit.
To adjust wheel height, open ring on lynch pin and remove pin. Move
to desired location and reinstall pin and close ring.
ASSEMBLY
Left Side
Right Side
Page 1 of 4
Summary of Contents for 10002626
Page 1: ...3 Nail Drag with Wheel Kit Product Manual...
Page 2: ......
