8
NS-231USB/431USB
9
NS-231USB/431USB
Hardware Installation
4.Connect the USB peripheral devices to the USB hub on the back
panel of the KVM Switch.
Powering-Up the KVM Switch
1.Connect the barrel of 5V, 2.5A power adapter to the power jack on the
back panel of the Switch.
2. Plug the power adapter cable into an available power outlet.
Hardware Installation
Connecting the Computers
1.Connect the USB (type A) KVM cable from your computer’s USB port
to the KVM Switch PC port.
2.Connect the VGA (HDDB 15 Pin) cable from your computer to the KVM
Switch PC port.
3.Repeat steps 1 and 2 for all computers.
4.Power on your computers. The operating system should recognize
your KVM Switch and will automatically install the HID USB driver if
necessary.
NOTE :
The Switch’s default link is the first powered on computer during
the installation. For some computers, you must enable USB
connector on your system BIOS. Please reference your computer
manual or motherboard manual to enabled the USB support.
�� ��� ����� ����� �������