Newport PMC-200, Manual

Page: 11 / 42

1
Section 1
Introduction
The PMC200/200-P is a 2-axis motion controller designed to drive Newport
Model 495 and 496 integrated motorized rotation stages, and 850 Series
motorized drives. Utilizing motion control ICs and a Motorola 68000 host
processor, the PMC200/200-P performs all the position and velocity control
for each axis. This is a digital control system, so analog compensation and
velocity feedback are not necessary. The axes are set up and controlled in
an easy-to-learn, menu-driven environment. Using the setup routines, you
have complete control over axis movement, including setting absolute jog
step and compensating for backlash and positioning errors. A non-pro-
grammable version (PMC200) without RS232 and IEEE-488 interfaces is
available. Model PMC200 controllers may be upgraded to the PMC200-P at
the factory.
The purpose of this manual is to document the setup and operation of the
Newport Corporation PMC200/200-P 2-Axis Motion Controller for use with
495 and 496 motorized stages, and 850 series motorized drives.
The PMC200/200-P was thoroughly tested and inspected before shipping.
Prior to unpacking the equipment, carefully inspect the outer containers for
signs of damage. If you find any damage, immediately notify the shipping
company and contact Newport Corporation for further instructions.
NOTE
Retain the original packing materials. They will be necessary if
reshipment of the product is in order. They can also be useful for
transporting the equipment to other locations.
The following table lists the components that you should have received
with your order.
Model # Quantity Description
PMC200/200-P 1 2-Axis Controller Unit
1 Power Cable
The following accessories may be ordered separately.
Model # Description
PMC200-J IBM PC-Compatible Joystick
850IA-10 15-Pin D to 9-Pin D Interconnect Cables
(one required for each axis)
1.1
System Overview
Scope of the Manual
1.2
1.3
Unpacking and
Inspection
System
Accessories
1.4