DISPLAY ABBREVIATIONS
ALR1
Alarm 1 Status
OFF
Alarm 1 set Off
ON
Alarm 1 set On
A1Md
Alarm 1 Mode
A1LO
Alarm 1 Low
A1HI
Alarm 1 High
A1LH
Alarm 1 Low/High
LO-1
Alarm 1 Low
-999..
Alarm 1 Low Value
..9999
HI-1
Alarm 1 High
-999..
Alarm 1 High Value
..9999
A1CR
Display color when Alarm 1 triggered
GRN
Green Color
REd
Red Color
AMbR
Amber Color
ALR2
Alarm 2 Status
OFF
Alarm 2 set Off
ON
Alarm 2 set On
A2Md
Alarm 2 Mode
A2LO
Alarm 2 Low
A2HI
Alarm 2 High
A2LH
Alarm 2 Low/High
LO-2
Alarm 2 Low
-999..
Alarm 2 Low Value
..9999
HI-2
Alarm 2 High
-999..
Alarm 2 High Value
..9999
A2CR
Display color when Alarm 2 triggered
GRN
Green Color
REd
Red Color
AMbR
Amber Color
OUt
Alarm Latched/Unlatched selection
LAtC
Latched
UNLA
Unlatched
NO.CR
Display Color in Normal condition
GRN
Green Color
REd
Red Color
AMbR
Amber Color
MOdE
Data Flow Mode
HOSt
Host Mode
SLAV
Slave Mode
bAUd
Baud Rate
300..
Baud Rate Value
..19200
FORM
Data Format
7O1
7 Bit, Odd,
7E1
7 Bit, Even,
1 Stop Bit
1 Stop Bit
8N1
8 Bit, No parity,
1 Stop Bit
COMM
Communication Standard
232
RS-232 Standard
485
RS-485 Standard
AddR
Device Address
0000..
Address Value
..0099
INtF
Interface Device
dRNt
DRN with
dRNP
DRN with
Temperature Input
Process Input
Miscellaneous:
PEAk
Peak Value
VALL
Valley Value
PROC
Process Value
RUN
Run Mode
OVLd
Input Overload
StOR
Stored Message
1. In
Slave
Mode the Big Display will wait for
commands and data from the Serial Bus.
2. In
Host
Mode the Big Display will send data
automatically and continuously into the Serial Bus.
3. When used in
RS-485
Mode, the device must be
accessed with an appropriate
Address
Value.
4.
Latched
Mode: Alarm remains latched until reset.
To reset already latched alarm select any menu
items and then press “up” or “down” button.
FLOW
CHART
_____Underline
denotes
factory
default
setup
Below
is
a
flowchart
showing
how
to
navigate
through
all
menus
by
pressing
front
buttons.
a
aa
a
aa
a
d
d
d
d
d
d
d
d
c
b
c
b
c
b
c
b
c
b
c
b
d
d
c
bd
c
bd
d
d
d
d
a
d
c
b
d
a
a
dd
d
a
c
b
c
b
dd
d
a
a
d
c
b
d
c
b
a
dd
d
a
c
b
c
b
dd
d
a
a
d
c
b
d
c
b
d
a
c
b
d
bc
c
b
c
b
c
b
c
b
SPECIFICATION
Temperature Stability:
50 ppm/°C
Display:
4-digit, 7-segment LED, 101.6mm (4.00”)
with red, green and amber programmable
colors.
Alarm:
Alarm 1 & 2 programmable,
Latch/Unlatch, High, Low, High/Low
Standards Compliance:
IEEE 802.3 10Base-T
Supported Protocols:
TCP/IP, ARP, HTTPGET
SERIAL INTERFACE
Communication Standard:
RS485, RS422
Transfer speed (Baud rate):
300, 600, 1200, 2400, 4800, 9600,
19200 bps
Data Format:
7O1-7 bit, Odd, 1 stop bit, 7E1- 7 bit,
even, 1 stop bit
8N1 – 8 bit, No parity, 1 stop bit
Multi-point Address (RS485):
0 to 199
Flow Control:
No Flow control
Screw terminals for RS-485/422
interface
NETWORK INTERFACE
10Base-T port (RJ45 connector)
Socket Port number:
1000
HTTP Port number:
80
Power Supply:
100-240 Vac ±10%, 50/60 Hz, 22.5 W
Operating Temperature:
0 to 40°C
Storage Temperature:
-20 to 60°C
Relative Humidity:
0 to 85%
Protection:
NEMA-4x (IP65)
Dimensions:
480.0 L x 210.8 W x 95.4 D mm
(18.11" x 8.31" x 3.76")
Panel Cutout:
414.3 L x 179.4 W mm
(16.31” L x 7.06” W)
Weight:
2,495 g (5.5 lbs)
Approvals:
CE per EN50081-1, EN50082-2,
EN61010-1
OPERATION MANUAL
M3838/N/0703
It is the policy of NEWPORT to comply with all worldwide safety and EMC/EMI regulations that apply.
NEWPORT is constantly pursuing certification of its products to the European New Approach Directives.
NEWPORT will add the CE mark to every appropriate device upon certification.
The information contained in this document is believed to be correct, but NEWPORT Electronics, Inc.
accepts no liability for any errors it contains, and reserves the right to alter specifications without notice.
TRADEMARK NOTICE:
,
,
,
and
newportUS.com
are trademarks of NEWPORT Electronics, Inc.
This device is marked with the international caution symbol. It is important to read the
Setup Guide before installing or commissioning this device, as the guide contains important
information relating to safety and EMC.
WARNING:
These products are not designed for use in, and should not be used for, patient-
connected applications.
WARRANTY/DISCLAIMER
NEWPORT Electronics, Inc. warrants this unit to be free of defects in materials and workmanship for a period of
one (1) year
from the date of purchase. In addition to NEWPORT’s standard warranty period, NEWPORT
Electronics will extend the warranty period for
four (4) additional years
if the warranty card enclosed with each
instrument is returned to NEWPORT.
If the unit malfunctions, it must be returned to the factory for evaluation. NEWPORT’s Customer Service
Department will issue an Authorized Return (AR) number immediately upon phone or written request. Upon
examination by NEWPORT, if the unit is found to be defective, it will be repaired or replaced at no charge.
NEWPORT’s WARRANTY does not apply to defects resulting from any action of the purchaser, including but not
limited to mishandling, improper interfacing, operation outside of design limits, improper repair, or unauthorized
modification. This WARRANTY is VOID if the unit shows evidence of having been tampered with or shows
evidence of having been damaged as a result of excessive corrosion; or current, heat, moisture or vibration;
improper specification; misapplication; misuse or other operating conditions outside of NEWPORT’s control.
Components which wear are not warranted, including but not limited to contact points, fuses, and triacs.
NEWPORT is pleased to offer suggestions on the use of its various products. However, NEWPORT neither
assumes responsibility for any omissions or errors nor assumes liability for any damages that result from
the use of its products in accordance with information provided by NEWPORT, either verbal or written.
NEWPORT warrants only that the parts manufactured by it will be as specified and free of defects.
NEWPORT MAKES NO OTHER WARRANTIES OR REPRESENTATIONS OF ANY KIND WHATSOEVER,
EXPRESS OR IMPLIED, EXCEPT THAT OF TITLE, AND ALL IMPLIED WARRANTIES INCLUDING ANY
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY
DISCLAIMED.
LIMITATION OF LIABILITY: The remedies of purchaser set forth herein are exclusive, and the total liability
of NEWPORT with respect to this order, whether based on contract, warranty, negligence, indemnification,
strict liability or otherwise, shall not exceed the purchase price of the component upon which liability is
based. In no event shall NEWPORT be liable for consequential, incidental or special damages.
CONDITIONS: Equipment sold by NEWPORT is not intended to be used, nor shall it be used: (1) as a "Basic
Component" under 10 CFR 21 (NRC), used in or with any nuclear installation or activity; or (2) in medical
applications or used on humans. Should any Product(s) be used in or with any nuclear installation or activity,
medical application, or used on humans, or misused in any way, NEWPORT assumes no responsibility as set forth
in our basic WARRANTY/DISCLAIMER language, and, additionally purchaser will indemnify NEWPORT and hold
NEWPORT harmless from any liability or damage whatsoever arising out of the use of the Product(s) in such a
manner.
RETURN REQUEST/INQUIRIES
Direct all warranty and repair requests/inquiries to the NEWPORT Customer Service Department. BEFORE
RETURNING ANY PRODUCT(S) TO NEWPORT, PURCHASER MUST OBTAIN AN AUTHORIZED RETURN
(AR) NUMBER FROM NEWPORT’S CUSTOMER SERVICE DEPARTMENT (IN ORDER TO AVOID
PROCESSING DELAYS). The assigned AR number should then be marked on the outside of the return package
and on any correspondence.
The purchaser is responsible for shipping charges, freight, insurance and proper packaging to prevent breakage
in transit.
FOR
WARRANTY
RETURNS,
FOR
NON-WARRANTY
REPAIRS,
please consult NEWPORT for current
have the following information available
repair BEFORE contacting NEWPORT:
charges. Have the following information
available BEFORE contacting NEWPORT:
1.
Purchase Order number under which
1. Purchase Order number to cover the
the product was PURCHASED,
COST the repair,
2.
Model and serial number of the
2. Model and serial number of product,
product under warranty, and
and
3.
Repair instructions and/or specific
3. Repair instructions and/or specific
problems relative to the product.
problems relative to the product.
NEWPORT’s policy is to make running changes, not model changes, whenever an improvement is possible. This
affords our customers the latest in technology and engineering.
© Copyright 2003 NEWPORT Electronics, Inc. All rights reserved.
This document may not be copied, photocopied, reproduced, translated, or reduced to any electronic medium or
machine-readable form, in whole or in part, without the prior written consent of NEWPORT Electronics, Inc.
PATENT NOTICE:
This product is covered by one or more of the following patents: U.S. Pat. No. Des. 336,895;
5,274,577; 6,243,021/ Canada 2052599; 2052600/ Italy 1249456; 1250938/ France Brevet No. 91 12756/ Spain
2039150; 2048066/ UK Patent No. GB2 249 837; GB2 248 954/ Germany DE 41 34398 C2.
™
is a Trademark of
OMEGA ENGINEERING, INC. USED UNDER LICENSE. Other U.S. and International patents pending or applied
for.
iLD44-EI
Big Display with
Embedded Ethernet
For immediate technical or application assistance please call:
Newport Electronics, Inc.
2229 South Yale Street • Santa Ana, CA • 92704 • U.S.A.
TEL: (714) 540-4914 • FAX: (203) 968-7311
Toll Free: 1-800-639-7678 • www.newportUS.com • e-mail:[email protected]
ISO 9001 Certified
Newport Technologies, Inc.
976 Bergar • Laval (Quebec) • H7L 5A1 • Canada
TEL: (514) 335-3183 • FAX: (514) 856-6886
Toll Free: 1-800-639-7678 • www.newport.ca • e-mail:[email protected]
Newport Electronics, Ltd.
One Omega Drive • River Bend Technology Centre
Northbank, Irlam • Manchester M44 5BD • United Kingdom
Tel: +44 161 777 6611 • FAX: +44 161 777 6622
Toll Free: 0800 488 488 • www.newportuk.co.uk • e-mail:[email protected]
Newport Electronics B.V.
Postbus 8034 • 1180 LA Amstelveen • The Netherlands
TEL: +31 20 3472121 • FAX: +31 20 6434643
Toll Free: 0800 0993344 • www.newport.nl • e-mail: [email protected]
Newport Electronics spol s.r.o.
Frystatska 184, 733 01 Karviná • Czech Republic
TEL: +420 59 6311899 • FAX: +420 59 6311114
Toll Free: 0800-1-66342 • www.newport.cz • e-mail: [email protected]
Newport Electronics GmbH
Daimlerstrasse 26 • D-75392 Deckenpfronn • Germany
TEL: 49 7056 9398-0 • FAX: 49 7056 9398-29
Toll Free: 0800 / 6397678 • www.newport.de • e-mail: [email protected]
Newport Electronique S.A.R.L.
11, rue Jacques Cartier • 78280 Guyancourt • France
TEL: +33 1 61 37 29 00 • FAX: +33 1 30 57 54 27
Toll Free: 0800 466 342 • www.newport.fr • e-mail: [email protected]
Mexico and Latin America
FAX: 001 (203) 359-7807
En Español: 001 (203) 359-7803
