Newport 6155AS, Manual

Page: 6 / 32

3 U02124ML-01-UK
SECTION 2
GETTING STARTED
2.1 UNPACKING AND INSPECTION
Your 6155AS remote display was systematically inspected and tested, then
carefully packed before shipment. Unpack the instrument and inspect for
shipping damage. If damage exists, do not attempt to operate the unit. Notify
the freight carrier immediately.
2.2 SAFETY CONSIDERATIONS
As delivered from the factory/distributor, this instrument complies with
required safety regulations. To prevent electrical or fire hazard and ensure
safe operation, please follow the guidelines below:-
POWER VOLTAGE
- Verify that the instrument is connected for the power
voltage rating that will be used. If not, make the required changes as
indicated in section 4.1 of this manual. This instrument is delivered with A.C.
power connection for 230V in Europe and for 115V in the USA as standard
(unless the instrument is fitted with DC drive capability). Verify that the
instrument is configured for the power voltage rating that will be used (See
Section 4.1).
POWER WIRING
- This instrument has no power on switch; it will be in
operation as soon as the power is connected.
Verify that the power cable has the proper ground (earth) wire and that this
wire is properly connected to a ground (earth) point. If the panel cut-out is a
metal enclosure, it must be grounded (earthed).
This instrument is protected according to the class I of the IEC (International
Electrotechnical Commission) 348 and VDE 0411 regulations.
RAIN OR MOISTURE
- Do not expose the instrument to condensing moisture.
FUMES AND GASES
- Do not operate the instrument in the presence of
flammable gases or fumes; such an environment constitutes a definite
safety hazard.
EXERCISE CAUTION
- As with any electronic instrument, high voltage may
exist when attempting to install, calibrate, or remove parts of the instrument.