Newland NLS-HR15, User Manual

Page: 238 / 300

Enter Setup
** Exit Setup 222
Change Data Format for a Single Scan
You can switch between data formats for a single scan. The next barcode is scanned using the data format selected here,
then reverts to the format you have selected above.
For example, you may have set your scanner to use the data format you saved as Format_3. You can switch to Format_1
for a single trigger pull by scanning the Single Scan
– Format_1
barcode below. The next barcode that is scanned uses
Format_1, then reverts back to Format_3.
Note: This setting will be lost by removing power from the scanner, or turning off/ rebooting the device.
Single Scan
– Format_0
Single Scan
– Format_1
Single Scan
– Format_2
Single Scan
– Format_3