Enter Setup
** Exit Setup
126
Enable Data Format
After enabling the Data Formatter, you may select a data format you want to use by scanning the
appropriate barcode below.
** Format_0
Format_1
Format_2
Format_3
Change Data Format for a Single Scan
You can switch between data formats for a single scan. The next barcode is scanned using the data
format selected here, then reverts to the format you have selected above. For example, you may have
set your scanner to the data format you saved as Format_3. You can switch to Format_1 for a single
trigger pull by scanning the
Single Scan – Format_1
barcode below. The next barcode that is scanned
uses Format_1, then reverts back to Format_3.
Note: This setting will be lost
by removing power from the scanner, or turning off/ rebooting the device.
Single Scan – Format_0
Single Scan – Format_1
Single Scan – Format_2
Single Scan – Format_3
Summary of Contents for HR3290 Marlin
