DRAFT
2
RHINO
™
6000+
User Guide
Connecting the Power
The label maker can operate on battery or AC power. A power adapter and a
rechargeable battery is included with your printer.
To save power, the label maker will automatically turn off after five minutes of
inactivity.
Make sure to read the
Safety Precautions for Rechargeable Battery
33.
Connecting the Power Adapter
The printer uses a 110V-240V power adapter. Connecting the power adapter with
the battery inserted recharges the battery.
Use only the power adapter listed in this user guide:
Adapter model DSA-18PFM-09 F
c
090200 (note: “c” can be EU, UP, UK, US, UJ, JP,
CH, IN, AU, KA, KR, AN, AR, BZ, SA, AF or CA) from Dee Van Enterprise Co., Ltd.
To connect the power adapter
1
Plug the power adapter into the power
connector on the bottom of the label
maker. See Figure 2.
2
Plug the other end of the power adapter
into a power outlet.
Inserting the Battery
The label printer is powered by a LiPolymer 7.4V 1400mAh 10.36Wh rechargeable
battery. Only use the battery that came with the label printer.
Make sure to read the
Safety Precautions for Rechargeable Battery
33.
To insert the battery
1
Press the thumb latch on the back of
the label maker to remove battery
compartment cover. See Figure 3.
2
Insert the battery pack into the
battery compartment.
3
Replace the battery compartment
cover.
Recharging the Battery
The battery automatically recharges while the printer is connected to a power
source through the power adapter. Charging the battery for the first time will take
approximately 8 hours; recharging the battery will take approximately 3.5 to 4
hours.
Figure 2
Press
thumb latch
to open
Figure 3
