20
Measurement results are saved in on-board memory in sets
depending on the parameters set for measuring, for instance,
if only distance is measured - the set will consist of one
number, if distance and azimuth are measured – the set will
consist of two numbers.
To enter the
Data Recall
mode press the M button in the
Ready to Measure
mode until
rEc
is displayed and then
press the A button. First measurement set number (display
name:
rEc
1
) will start flashing.
Pressing the M button moves the unit along the list of
measurement set numbers and measurement results:
rEc
1
, distance 1, azimuth 1,
rEc
2
, distance 2, azimuth 2, …,
rEc 0
, distance 0, azimuth 0.
Measurement sets are numbered in reverse order: first
recalled set is the result of the last measurement. If any
parameter has not been actually measured it will not be
recalled.
Pressing the A button at any moment within the list of
recalled results (or pressing the M button at the end of the
list) brings the unit to the
Ready to Measure
mode.
Choosing
cLr
in
Setup
mode will erase all measurement
data.
