16
Flashing display name indicates the mode which can be
selected by pressing the A button (4).
Setup and Data Recall
modes have submenus, so when the A
button is pressed to select these
modes the unit automatically
enters the corresponding submenu. In the same way as with
the mode switching, the M button switches between submenu
items and A selects the needed one. When the A button is
pressed from the submenu the unit comes into the
Ready to
Measure
mode with the selected parameter.
If no button is pressed for 8 seconds the unit leaves the
current mode, in the
Ready
mode it switches off. Next time
the unit is turned on it assumes the last chosen combination of
the four
Ready to Measure
mode parameters.
Note:
On a special request menu of a particular unit can be
simplified to show only required modes.
Setup mode
To modify the four
Ready to Measure
mode parameters:
Enter the Setup mode.
With word
Ready
on the display press the M button till
display name
COdE
is displayed and press the A
button.
Select the desired parameter modification (see table
below).
Press the M button till the code name of the desired
parameter is displayed and press the A button.
