3
COFFEE PREPARATION PROCEDURES
1) Place the filter into brew basket.
2) Place the appropriate amount of ground coffee into the filter for the volume of coffee to be brewed.
3) Slide the brew basket into holder.
4) For warmer units:
Place empty decanter on warmer located directly under the brew basket
Turn corresponding warmer switch to ON position.
For airpots or other dispensers
Remove any non brew thru lids or pump stems
Place airpot under brew basket.
Turn the power switch on.
5) Depress the brew start switch.
6) For manual brewing, raise the top evaporation cover and pour ONE decanter(warmer model) or pitcher(therm
model) of COLD water through the pour in grid into the basin. Ensure that lower warmer/power switch is in the
ON position to start the brew cycle.
7) To cancel brew cycle turn the lower warmer switch for warmer models, or power switch for thermo models, to
the off position. Some hot water will continue to drain from the system.
8) NOTE: Never pour hot water into the brewer. This brewer features a European style brewing system which
heats only the water for coffee when you pour it into the brewer. This type of system does not have a tank to
store hot water. Do not overfill unit by pouring in more than one decanter of water at a time.
9) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed
within the brew basket. After heating stops, coffee will continue to drain from the brew basket into the decanter
below.
10) The unique thermal brew system takes a little longer to brew than tank systems, which allow the stored water to
become stale, but the result is better tasting and hotter coffee.
11) (AKH warmer model) TURN OFF WARMERS WHEN NOT IN USE. Red light in switch indicates when warmer
is ON.
12) To clean brew basket simply remove from brew rails and dump filter into waste basket. The brewing process,
as described above, can now be started again.
If unit will not brew, check the following before calling for service:
Is it plugged in?
Is there water in the receiving pan? Water activates the float switch, allowing the unit to brew.
(Warmer model) Is the lower warmer switch in the ON position?
(Thermal model) Is the power switch in the ON position?
WARRANTY
Newco coffee brewers are warranted against defects in workmanship or materials, under normal use, for one year
from the date of purchase.
Liability in all events is limited to the purchase price paid and liability under the aforesaid warranty is limited to
replacing or repairing any part or parts which are defective in material or workmanship, and returned to our factory,
shipping cost prepaid. No warranty expressed or implied, other than the aforesaid is made or authorized by Newco
Enterprises, Inc.
Prompt disposition will be made if item proves to be defective, within warranty. Before returning any item, write or
call Newco, or the dealer from whom the product was purchased, giving model number, serial number, and date of
purchase, and describe nature of the defect. If damage was incurred during transit to you, file claim with the carrier.
