INSTALLATION INSTRUCTIONS - GAS
ASSEMBLE GRILL
Fitting the grill canopy
Fixing screws and washers that are not
loosely assembled in position are in
the plastic bag in the oven pack.
1. There are 2 sets of screws in the back
of the cooker which will secure the
splashplate (through the uprights) onto
the back of the cooker.
2. Loosen the lower screws of each set in
the back of the cooker, until some of the
thread is showing.
3. Remove the upper screws in each set
and keep to hand. Pick up the splash-
plate and grill canopy and lower it onto
the back of the cooker so the slots in the
uprights locate over the loosened screws.
4. Replace the upper screws through the
slotted holes and tighten all of the screws
in turn.
5. Connect the grill pipe from the tap rail
to the straight hexagon connector.
Make sure the connections are gas
sound
Thermocouples
Locate the spring clip in the grillpan.
Carefully uncoil the grill thermocouple and
feed through the correct hole (see label
on splashback). Insert thermocouple into
grill burner bracket and secure with the
spring clip. Coil the thermocouple to take
up any slack ensuring there are no sharp
bends or kinks.
Grill electrode lead
Feed the grill electrode lead through the
hole at the top left-hand corner of the
splash plate (viewed from rear) and con-
nect it to the grill electrode. Do not feed
the wire through the grill shelf wire slots.
Fit the grill shelf
Note: For ease of assembly, slacken the 4
screws holding the canopy to the splash
plate, before offering up the grill shelf.
- If the grill shelf has mounting
holes:
1. Remove the four grill shelf fasteners
which are loosely assembled in position on
the underside of the grill canopy.
2. Offer the grill shelf up to the underside
of the grill canopy with the rubber end
caps against the splashplate and use the
four fasteners to fix in place.
3. Retighten the 4 screws holding the
canopy to the splashplate.
- If the grill shelf has mounting slots:
1. Loosen but do not remove the grill
shelf fasteners until some thread is visible.
These are loosely assembled in position
on the underside of the grill canopy.
2. Slide the shelf, with it’s rubber end
caps against the splashplate, under the
fasteners on one side to locate it.
3. Push the other end under the fasteners
on the other side of the canopy, applying
some pressure to enable location. Tighten
all 4 fasteners to fix in place.
4. Retighten the 4 screws holding the
canopy to the splashplate.
Fit the grill pan
Place the grill pan onto the grill pan run-
ners and push to the back stop position,
raise the front edge of the grill pan to
engage it onto the grill pan runners. The
grill pan can now be pulled forwards to fit
the front stop position.
