RAD-TV USER MANUAL
New World Technologies
Page • 7
V2014.07.15
1.2.3 Charging Specifications
Units
240 mAh
Charge Time
Hours
Approx. 1
Storage Time
(Must be fully Charged)
Months
3-4
Table 3: Charging Specifications
1.2.4 Environmental Specifications
CAUTION!
Only operate the RAD-TV Tool System if the following environmental storage and operation
specifications have been met.
All Models
Ambient Operating Temperature Range
°C
°F
Pneumatic Only
Operating Temperature
-20 to 40
-4 to 104
Pneumatic with Electronics
Optimum Battery Life
5 to 35
41 to 95
Absolute Maximum
1 to 60
34 to 140
Ambient Charging Temperature Range
°C
°F
Temperature at Charging
0 to 45
32 to 113
Storage Temperature Range
°C
°F
Optimum Battery Life
-20 to 45
-4 to 113
Storage More than 3 Months
0 to 30
32 to 86
Humidity
10% to 90% non-condensing
Table 4: Environmental Specifications
2.0
Battery Usage and Charging
This section provides instructions for safe usage and charging of the RAD-TV internal LiPo
battery.
WARNING!
Do not operate the tool or charge the batteries before reading the safety instructions and
warnings detailed in this manual. If breakdown, malfunction or damage occurs, DO NOT
attempt to repair. Contact New World Technologies Inc. or your Local Distributor immediately.
WARNING!
Lithium Polymer (LiPo) batteries are volatile.
Failure to read and follow these instructions may
result in fire, personal injury and/or damage to property if charged or used improperly.
2.1 General Safety Warnings and Guidelines
The RAD-TV is assembled, calibrated and shipped with a rechargeable Lithium Polymer (LiPo)
battery
1.
Batteries are NOT fully charged as you receive them. They may contain
approximately 50% of a full charge.
2.
Use the New World Technologies Inc. supplied USB Charger only. Do not use
any other Lithium Polymer or NiCd or NiMh charger - Failure to comply may
cause a fire, which may result in personal injury and/or property damage.
3.
Never charge the tool unattended.
When the LiPo batteries are charging, they
should always remain under constant observation so you can better react to
any potential problems that may occur.
4.
Charge in an isolated area, away from flammable materials.
5.
Let the RAD-TV battery cool down or warm up to recommended ambient
temperature before charging.
6.
If there is any sign of damage to the charger or charging cable, do not attempt
to charge the tool/battery. Unplug the charger immediately.
7.
If there is any sign of damage to the tool housing or to the battery pack, do not
attempt to charge
8.
If there is any sign of damage to the battery pack or the battery pack is leaking,
do not attempt to charge or make direct contact. If battery fluid comes into
direct contact with skin or eyes, flush immediately with fresh, clean water and
contact a physician.