New Rock Technologies MX100-TG, User Manual

Page: 48 / 75

Configuring the MX100-TG
MX100-TG User Manual
48
0x08 Maximize throughput
0x10 Minimize delay
It is also possible to set multiple bits. For example a setting of
0x18
would set IP TOS to maximize throughput and minimize delay.
T.38
Enable T.38
Enables or Disables the T.38 fax function. If T.38 is enabled it is
necessary to configure the following T.38 parameters.
Packet Time (ms)
This parameter is used to set the packing interval of the T.38 data
frame. The value can be set to 10 , 20 , 30 , 40 , 50 , or 60 ms.
Redundancy
This parameter configures the number of T.38 data frames in each
T.38 data packet. T.38 Redundancy may be set from 1 - 6 . The
default setting is 4 .
Change Port
When configured to Enable , the MX100-TG will change the UDP
port when switching to T.38 mode. If T.38 Change Port is set to
Disable the MX100-TG will reuse the RTP port number that was
used in the creation of the connection.
T.38 ECM Mode
The T.38 ECM Mode may be set to Enable or Disable .
V.21 Detect
Enable or Disable V.21 signal detection.
Jitter Size
The jitter size range is from 0 to 1000ms. The default setting is 250 .
Receive Gain
The receive gain set between 1 and 4, while set to 1 will adjust
signal to one half of its original amplitude, set to 2 will keep the
original signal amplitude, set to 3 will adjust signal to 2 times of its