New Holland TS-100A, Assembly & Instruction Manual

Page: 104 / 154

© 2005
Alamo Group Inc. Section 10 - 10
New Holland (NH TS-100A, 115A, 125A, 135A Asy. Man) 01/05
CONTROL VALVE - INSTRUMENTATION
Maverick Operator Interface
: (continued)
*
Key the corresponding F-key for the head attachment that will be used, This is an important step
because this parameter chooses which direction the fluid will enter the motor. The Timbercat Sicklebar
mower is the only head attachment that currently requires the operator to send reverse flow, for all
others chose F-1 key for standard directional flow.
*
Key F-1 to activate Joystick, the Boom will not move until the joystick is activated. The Boom function
Set-up is now complete, the boom speed, the head attachment has been chosen and the joystick has
been activated.
*
Key F-1 to power motor. This is best done when the engine RPM is at idle speed. Doing this a t high
RPM will cause the system pressure to surge sending fluid over the relief and causing excess heat to
be introduced into the system.
*
At any time the Cutter Head Motor E-Stop (emergency stop) can be pushed to disable the motor
circuit. If this is done the Switch must be raised in the run position before the motor circuit can be
reactivated.