Engine - Engine and crankcase
Engine - Install
WARNING
Avoid injury!
Handle all parts carefully. Do not place your hands or fingers between parts. Use Personal Protec-
tive Equipment (PPE) as indicated in this manual, including protective goggles, gloves, and safety
footwear.
Failure to comply could result in death or serious injury.
W0208A
To re-install the engine, proceed as follows:
• Mount the support for the radiator cores on the en-
gine with the four screws. Remember to insert the
washers as a spacer on the two upper screws.
• Re-fit the hood damper support. Re-connect the up-
per radiator support.
Refit the support with the grid heater relay and sup-
ply cable. Connect it to the alternator with the charge
cable. Connect the supply cable to the relay at the
grid heater element.
• Reinstall:
• Upper radiator sleeve
• Air cleaner/turbocharger sleeve
• Oil filter collection pipe/air cleaner
• Intercooler right-hand sleeve
On the left-hand side:
• Intercooler left-hand sleeve
• Refit the lift oil filter including the supply pipe to the
pump.
• Refit the pump unit, including the oil supply pipe,
to the lift. Reconnect the intake pipe to the pump.
Connect the inlet pipe and the supply pipe to the
Steering-O-Matic pump. Also fit the tank and the
related support.
For the TK4050 and TK4060 models, fit the bypass
valve assembly and the oil supply pipe to the trans-
mission.
• Reconnect the supply to the heat exchanger pump
on the bypass valve assembly. Reconnect the return
to the intercooler assembly.
• Reconnect the fuel supply pipe to the priming pump.
Reconnect the exhaust pipe to the injection pump.
• Reconnect the radiator lower sleeve and refit the
plug.
• Refit the muffler and related flame shield.
• Refit the right- and left-hand fan guards.
• Refit the right- and left-hand support of the safety
roof.
• Fill up the engine refrigerant with the product and
quantity prescribed in
Consumables ()
.
• Carry out the operations for the implement clutch
Clutch - Remove (18.110)
.
47830952 26/03/2015
10.1 [10.001] / 7