11
Lowering Attachments
1. Depress the brake and/or clutch pedal(s) to stop the
tractor.
2. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release the
latch. Move lift lever forward to lower attachment.
1205
3
2
4
5
6
1
Figure 18
1.
Lift lever
2.
Button
3.
Dial-A-Height
4.
Indicator
5.
High
6.
Mounting position
Attachment Power Lift
The attachment power lift (on some models) (Fig. 19) is
used to raise and lower attachments.
Raising Attachments
1. Turn key to the “ON” or “RUN” position (Fig. 19).
2. Push the lift switch in the “UP” direction to raise the
attachment lift (Fig. 19). This will lift and hold the
attachment in the up, or raised position.
Lowering Attachments
1. Turn key to the “ON” or “RUN” position (Fig. 19).
2. Push the lift switch in the “DOWN” direction to lower
the attachment lift (Fig. 19). This will lower the
attachment lift.
2266
2
1
3
Figure 19
1.
Key
2.
Lift switch UP
3.
Lift switch DOWN
Adjusting Dial-A-Height
The Dial-A-Height control (Fig. 18) is used to limit the
downward travel of the attachment. The Dial-A-Height
knob is rotated to change the location of this stop, up or
down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised, position the Dial-A-Height
knob (Fig. 18) can be rotated to change the stop
location. Turn clockwise to raise and counterclockwise
to lower the height of the attachment.
2. The Dial-A-Height indicator (Fig. 18) will show the
change, high to low, in attachment lift height as
adjustment is made.
Adjusting Gage Wheels
The gage wheels (on certain models) must be adjusted in
the proper hole location for each height-of-cut position.
1. After adjusting height-of-cut. raise the attachment lift
lever: Refer to Raising Attachments.
2. Remove hairpin cotter and pin to change hole location
(Fig. 20).
3. Select a hole position so the gage wheel is 3/8” (9.5
mm) off the ground for the height-of-cut to be used
(Fig. 20).
4. Insert pin and secure with hairpin cotter.