10
1
1
6
7
4
m–3644
2
3
3
2
Figure 16
1.
Link pin
2.
Washer 1/2”
3.
Hair pin cotter–small
4.
Attachment lift
5.
Lift arm
6.
Washer 3/4”
7.
Hair pin cotter–large
8. Raise attachment lift all the way to the latched
position. Turn the front wheels, as necessary, and slide
mower out to the the right side.
Note: Save all hardware, washers and hairpin cotters for
use when installing deck.
Operation
Side Discharge
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
•
NEVER remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear discharge area or mower
blades unless you move the power take off
(PTO) to “OFF” and rotate the ignition key to
“OFF.” Also remove the key and pull the wire
off the spark plug(s).
Warning
1. The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
Operating the
Power Take Off (PTO)
The power take off (PTO) engages and disengages power
to the electric clutch.
While the ignition key is in the “RUN” or “LIGHTS”
positions and the power take off (PTO) is engaged “ON“,
the PTO light, in the Indicator Module, will be “ON“.
When this light is “ON” it is a reminder; the starter will
not crank and to turn the off PTO before getting off.
Engaging the Power Take Off (PTO)
1. Depress the brake and/or clutch pedal(s) to stop the
tractor.
2. Pull the power take off (PTO) to “ON” (Fig. 17).
1
2
1206
Figure 17
1.
Off-Disengaged
2.
On-Engaged
Disengaging the Power Take Off (PTO)
1. Depress the brake and/or clutch pedal(s) to stop the
tractor.
2. Push the power take off (PTO) to “OFF” (Fig.17).
Attachment Lift Lever
The attachment lift lever (on some models) (Fig. 18) is
used to raise and lower various attachments.
Raising Attachments
1. Depress the brake pedal to stop the machine.
2. Pull attachment lift lever rearward until latch locks. In
this position the lift will hold the attachment in the up,
or raised position.