STEP ONE
Without inserting them completely, set one end rail and one middle
rail into the holes in one of the posts. Slide the spindles through the
middle rail and into the bottom rail as shown.
Lift up the panel and slip a second end rail onto the ends of the
spindles. Push down on the end of each rail until the tabs are
‘locked’ into the holes in the post.
Lay out a second post. Flip the panel over and line up the rail ends with
the corresponding holes in the post.
Slide one post trim cap over the top of each post. There is no need to
fasten the post trim cap in place at this point.
Assemble the Side Panels
1
3
2
www.newenglandarbors.com
4
1
2
3
2
If you purchased the extra Trim Kit, slide the second set of post trim
cap over the top of each post as well as the base trim to the bottom
of each post as shown.
Repeat steps 1 through 5 for the second side panel.
Richmond Grande Arbor
4
5
5
