Page 5
ASSEMBLY
NOTE:
Each steam mop is 100% tested in the factory to ensure product performance and safety. When
assembling your new steam mop for the first time you may notice water residue inside of the unit.
!WARNING:
Before attempting any of the following operations, make sure that the appliance is switched
off and unplugged and that the appliance is cold and contains minimal or no water.
Attaching the Handle
● Open the battery cover in the back part of handle, put in 4 AAA,
1.5v batteries, close the battery cover.
(Fig.1)
Notice: Please take out batteries when steam mop is not in use
for a long period of time.
● Slide the bottom end of the handle tube A into the top end of the
Hand-held Steamer Housing C until it clicks into place.
(Fig.2)
● Secure the assembled handle and pole by using the large screw
(Screwdriver not included).
(Fig.2)
Attaching the Steam Head (Fig.3)
● Slide the bottom end of Steam mop body C onto The steam head
D until steam head spindle 18 clicks into place.
● The Steam head D can be removed from the
Steam mop body C by pressing salient point on the Steam head D
spindle.
Attaching the Hand-held Steam Cleaner (Fig.4)
● Push the hand-held steam cleaner B firmly into the steam mop
body C until it clicks into place.
Attaching a Cleaning Pad (Fig.5)
● Because of barb design at the bottom of steam head D, just place
a micro-fiber cleaning pad F to steam head, it will securely attach.
● Place the front of your shoe onto the cleaning pad removal
Tab and press down firmly.
Attaching Carpet Glider (Fig.6)
● Press the micro-fiber cleaning pad H with main body to Carpet
gilder by applying vertical pressure until it clicks into place.
● Place the front of your shoe onto the cleaning pad removal tab
And press down firmly, carpet glider will remove from steam head.
fig.2