NEW BRUNSWICK SCIENTIFIC Innova 2000, User Manual

Page: 18 / 55

18
M1190-0050 Innova 2000/2050 User’s Guide
Table 1: User Interface Keys
Key Function
START/STOP This key is used to start or stop the shaking motion. It will also
activate or stop the timer when a timed run is desired.
S
T
These keys are used to adjust the setpoint of a displayed
parameter up or down. They also allow the user to enter the
SET mode for setpoint changes.
SELECT This key is used to change the displayed parameter.
NOTE: Temperature (
°
C) cannot be selected unless the
temperature/remote monitoring option is installed.
2.2.3 Status Indicators
Table 2 below explains the function of the four status indicator lights, which
are located to the left of the control panel display.
Table 2: Status Indicators
Status Light Function
MAINT Remains lit after 10,000 hours of use. Accumulated running time
is internally monitored and may be displayed as a guideline.
SET Indicates that the shaker is in the SET mode: setpoints are being
displayed and can be altered.
TIME Indicates that the timer is in operation. Innova shakers can be
programmed to run for a preset time from 0.1 hour to 99.9 hours.
The timer can be disengaged without stopping an ongoing run.
MUTE Indicates the status of the audible alarm: when the MUTE
indicator is illuminated, the audible alarm device is disabled.
2.2.4 Function Indicators
As show in Table 3 below, the four function indicator lights (located to the
right of the control panel display) show the current parameter being displayed:
Table 3: Function Indicators
Status Light Function
RPM Revolutions Per Minute shaking speed
HRS Hours: run time remaining
ºC Temperature in degrees Celsius (activated only if the optional
Temperature Monitor is installed)
* This function is not active in the Innova 2000 or 2050