26
Excella™ E-2 Classic Platform Shaker
M1350-0050
User’s Guide
Figure 4: Rear Panel
2. Using a small flat-bladed screwdriver, pull the fuse holder out of the power connector
assembly (
see Figure 8 below
).
Be careful:
the fuses may spring out of the holder.
Figure 8: Fuse Holder (detail)
3. Check the fuses. If either has failed, replace the fuse. (For fuse part number and
description, see Section 8.1.)
7.4 Troubleshooting
If any problems occur with your shaker, do not attempt to perform any service on the unit
other than specified in this manual. Unauthorized servicing may void the warranty.
Please contact your local NBS Service Department
In any correspondence with NBS, please refer to the Model Number and Serial Number
of your unit. This information is on the
ELECTRICAL SPECIFICATION PLATE,
located on
the rear panel of the unit near the
ON/OFF SWITCH
.
Insert
screwdriver tip
under this tab to
pry the fuse
holder out.
POWER
CONNECTOR
ON/OFF SWITCH
FUSE HOLDER
